Most homeowners consider how long do dishwashers last when making their purchase. However, the longevity of the dishwasher is determined a lot by how it is used. For example, standing water in the dishwasher required immediate repair to avoid permanent damage to the appliance. There are a number of reasons why this would occur, and most of these issues can be corrected at home without calling the home warranty professional. This article will cover the method of correcting standing water in the dishwasher, including:
- How to fix the problem
- Checking the drainage system
- Cleaning the pump
- Cleaning the sprayer arms
- Dishwater filter
- Supply line issues
- Drain line problem
- Other steps
How to fix the problem
First, turn off the dishwasher and unplug it completely. Also, switch off the circuit breaker as well. These steps ensure that you remain safe from a serious electric shock. Once unplugged, use towels to line the floor beneath the dishwasher. Then, scoop out the standing water using a plastic cup. Collect the water in a large bowl below to avoid the water spilling elsewhere. Finally, use the towels to remove any excess moisture.
Checking the drainage system
Once you are done with the water removal, you must check the drainage system. Mostly, food particles struck at the end of the dishwasher cause the water to clog inside completely. Clean the drain basket. Also, use a wire hanger to remove any debris that is clogging the system. Do not leave any large objects covering the sump area.
Cleaning the pump
Next, your pump requires cleaning as well. There are two impellers in the pump. The upper one provides water to the dishwasher, while the lower one drains out the used water. In some cases, broken cutlery such as glass pieces or food parties can damage the dishwasher and stop it from turning. Remove any clogging caused by the debris to make the dishwasher work again.
Cleaning the sprayer arms
Each sprayer arm can be popped out from the dishwasher at the bottom. Check the holes of the arms for any food debris that is clogging them. In case such debris is present, use a wire hanger to clean it. Use warm water to rinse the arm before setting it back in the dishwasher.
Dishwater filter
Each dishwasher has a filter located at a different location. Read through the owner’s manual to locate the filter. Once located, remove it using a screwdriver. In most cases, it is at the bottom of the dishwasher. After rinsing the filter with warm water, use a damp sponge to clean the rest of the area.
Supply line issues
If the above steps do not remove the drainage problem, there may be a problem with the supply line. The supply line is located directly under your sink. Collect the water underneath the sink using a bucket. Then, clean the line to remove any vlogs. After the clog is cleaned, you may not face the drainage issue with the dishwasher.
Drain line problem
In certain cases, the drain line may have an issue with the filter screen. Use a baking soda and water solution to make a paste. Pour the pastedown the drain line and leave it for a few minutes. You may use vinegar as well. Use hot water to remove the paste from the drainage system.
Other steps
You may straighten the drain hose to ensure that the water can drain easily. Similarly, dispose of any garbage to avoid blockage in the future. Avoid putting your hands on the garbage disposal. Finally, run a complete cycle to test if everything is working correctly. If not, contact your home warranty provider.
Conclusion
Before paying the service call-up fee, check your dishwasher for these issues that you can correct yourself. If these methods work, you can save up on the service call-up fee. I hope the article helped you save money on your dishwasher repairs.
